What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 23.06.2025 13:04

This device then solves the entire problem.
He then describes the function of a fuse.
Edit 2024–10.
PS5 has a huge price advantage over Xbox and Switch 2 right now - Eurogamer
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
At least they know the answer if they wanted it.
2024–10–16 [ OO OLAOYE OYEBODE ]
A fuse is a non-resetable over current circuit protector.
For this case there are devices called Metal oxide varistors (MOV).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Id ea voluptatem rerum temporibus expedita facere.
eight
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
I post the exact comment here.
Mitsubishi Said in Advanced Talks on $8 Billion Aethon Deal - Bloomberg.com
At one ohm, the resistor has a maximum of 1 watt power.
but this device (an Inductor) … impedes the rapid changes in the current.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
How likely is it that Israel would target targets in Iran if there is a full-blown conflict?
Here is a simplified AC power diagram.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
He then asserts :
This one hit behind the barn.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
The other is “what does a “fuse” do?”
NASCAR Saturday schedule at Pocono Raceway - NBC Sports
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is 'the assistant's answer'
These devices are installed between the “hot” and “neutral” and protective ground.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Why is Taylor Swift voting for Kamala Harris?
but I think this circuit , shows a few more pieces.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
There are three different concepts here that are getting confused.
Costco opens a whole new kind of store - TheStreet
[image of Common-mode choke]
what exactly is a ‘surge’ protector?
It seems Mohan does not understand the difference between a comment and an Answer.
What is your best forbidden sex story that felt so right?
An AC voltage/ current source, and an ac inductive load.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
nine
What does a fuse do?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
First Sentence:
a photo is worth a thousand words.
What is lightning?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The third is lightning and “how it gets conducted into a home.”
But… the neutral is now “floating” because of the 1 ohm resistance.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Because the load is inductive, the current lags the voltage.(by a bit).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–10[John johnson John Johnson ]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–14 [Omar Gharbi Omar Gharbi ]
One is “what exactly is in a ‘surge protector’ ? ”
the problem then depends on "how fast does the fuse operate?".
A circuit breaker is similar, but is resettable.
so, what happens?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
The MOV will conduct when the voltage exceeds 50% of line voltage.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is where the MOV conducts again, and dissipated the energy.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
These are simplified answers to the original question, and does not change anything I wrote above.
Upvotes:
He then describes Rainy Season and Lightning.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
[old diagram got deleted by accident]
So, the voltage could go up to 500 volts, and the fuse will not open up.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
There are two important concepts here.
One
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
(Dc diagram shown, AC is similar).
This is the picture of an electronic coil of wire wound around a core of magnetic material.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
In schematic diagrams this is the symbol for a fuse:
It also is a device that limits the change in current flow.
The bolt then partially travels down the line to your home.
Barnstars:
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
But it can get overloaded, and no longer works.